User`s manual

User's Manual 4. Initial Configuration
Version 2.2 49 July 2007
d. Enable the new configuration by typing the following command:
192.168.2.1(IF-IP)[WAN]# shutdown <CR>
192.168.2.1(IF-IP)[WAN]# no shutdown <CR>
e. Verify the new WAN IP settings by typing the following command:
192.168.2.1(if-ip)[WAN]# show ip interface WAN <CR>
f. Exit the WAN mode using the following command:
192.168.2.1(if-ip)[WAN]# exit <CR>
g. Continue to Step 6 to configure the default gateway IP address.
6. Configure the default gateway (relevant to Static and PPPoE WAN interface modes),
by typing the following command:
192.168.2.1(cfg)#
192.168.2.1(cfg)#context ip router <CR>
192.168.2.1(ctx-ip)[router]#route 0.0.0.0 0.0.0.0 <Default
Gateway IP> <CR>
In our example setup, the default gateway is defined as 10.33.0.1.
7. Save the configuration by typing the following command:
192.168.2.1 # store-running-config
For additional information on configuring the network settings, refer to Section 'Network
Settings' on page 118.