User`s manual

MediaPack BRI Series
User's Manual 46 Document #: LTRT-83702
4. Configure the LAN interface IP address, by performing the following:
a. From the main configuration mode, enter the “ip_interface” mode using the
following command:
192.168.2.1<cfg># ip_interface LAN <CR>
b. Configure the LAN interface static IP, using the following command:
192.168.2.1<if-ip>[LAN]#ipaddress <ip-address> <ip-mask>
<CR>
c. To enable the new configuration, perform one of the following depending on how
you accessed the CLI:
♦ RS-232: type the following commands:
192.168.2.1(if-ip)[LAN]# shutdown <CR>
<Newly assigned IP>(if-ip)[LAN]# no shutdown <CR>
Exit the LAN mode using the following command:
<Newly assigned IP>(IF-IP)[LAN]# exit <CR>
♦ Telnet: the connection to the MediaPack is lost if the LAN interface is
shutdown. Therefore, you must first save the configuration to flash by typing
the following command:
192.168.2.1 # store-running-config
Then reset the MediaPack by pressing on the reset button for more than two
seconds. After the MediaPack restarts, re-access the MediaPack by
repeating steps 1 to 3 using the newly assigned IP address.