User`s manual

MediaPack BRI Series
User's Manual 44 Document #: LTRT-83702
6. Under the WAN IP Configuration group, set the WAN ‘Interface Mode’ to one of the
following:
• Static: define the WAN static ‘IP Address’ and ‘Subnet Mask’ fields to correspond
with your IP network settings. To define the WAN Default Gateway, refer to Step
8.
• DHCP: ensure that you have a DHCP server in your WAN network. The assigned
IP address and subnet mask are displayed in the ‘Current IP Address’ and
‘Current Subnet Mask’ fields. (In our example setup for Unit A, the DHCP IP
address is defined as 10.33.2.35.)
• PPPoE: ensure that you have a PPPoE server in your WAN network. Define the
‘PPPoE Username’ and ‘PPPoE Password’ fields to correspond with your PPPoE
server authorization. The assigned IP address and subnet mask are displayed in
the ‘Current IP Address’ and ‘Current Subnet Mask’ fields. To define the WAN
PPPoE Default Gateway, refer to Step 8.
7. Click the Submit button; the MediaPack applies the changes.
8. To configure the default gateway (relevant for static and PPPoE WAN interface
modes), perform the following:
a. Access the 'Static Routing Table' screen (Advanced Configuration menu >
Network Settings submenu > Static Routes option).
Figure 4-5: Static Routing Table Screen
b. Add a static route entry with the following values based on our example setup:
♦ Dest IP: 0.0.0.0
♦ Dest Mask: 0.0.0.0
♦ GW IP (i.e., default gateway): 10.33.0.1
c. Click the Insert button; the static routing entry is added to the table, as shown in
Figure 4-5 above.
9. Save the configuration (refer to Section 'Saving the Configuration Settings' on page
61).