User`s manual

User's Manual 4. Initial Configuration
Version 2.2 39 July 2007
4 Initial Configuration
This section leads you through the initial and basic configuration procedures for setting up
the MediaPack. Initial configuration includes establishing IP connectivity with the device.
The initial and basic configuration comprises the following steps:
 Connecting the MediaPack to your PC (refer to Section 'Connecting MediaPack's LAN
Interface to your PC' on page 40)
 Configuring the MediaPack's IP address (refer to Section 'Configuring the
MediaPack's LAN and WAN IP Address' on page 41)
 Connecting the MediaPack to your network (refer to Section 'Connecting the
MediaPack to the Network' on page 50)
 Configuring the ISDN ports (refer to Section 'Configuring the ISDN Ports' on page 51)
 Configuring the ISDN interfaces (refer to Section 'Configuring the ISDN Interface' on
page 53)
 Configuring the SIP parameters (refer to Section 'Configuring the SIP Parameters' on
page 54)
 Configuring Coder Groups (refer to Section 'Configuring Coder Groups' on page 58)
 Configuring the IP to Tel Routing table (refer to Section 'Configuring IP to Tel Routing
Table' on page 59)
 Configuring the Tel to IP Routing table (refer to Section 'Configuring Tel to IP Routing
Table' on page 60)
 Saving the configuration (refer to Section 'Saving the Configuration' on page 58)
 Configuring the ISDN telephone units (refer to Section 'Configuring the ISDN
Telephone Units' on page 61)
 Establishing a call between units A and B (refer to Section 'Establishing a Call
between Units A and B' on page 62)
At the end of each step, a reference to the relevant section is provided where advanced
configuration options are described in detail.
The initial configuration described in this section is based on the network architecture
example shown in Figure 4-1. The configuration of MediaPack units A and B are almost
identical, and therefore, the initial configuration only relates to the configuration of unit A.