User`s manual

MediaPack BRI Series

User's Manual 28 Document #: LTRT-83702

3.3 Mounting the MediaPack

The MediaPack provides the following mounting options:

 Desktop mounted

 Wall mounted

 Installed in a standard 19-inch rack

3.3.1 Mounting the MediaPack on a Desktop

The MediaPack provides four rubber feet for desktop mounting. The feet are located near

each corner on the underside of the device, preventing the device from moving around on

your desk.

Figure 3-1: Desktop or Shelf Mounting

3.3.2 Installing the MediaPack in a 19-inch Rack

The MediaPack can be installed into a standard 19-inch rack by the addition of two

supplied brackets (1 short, 1 long), as shown in Figure 3-2.

Rack Mount Safety Instructions (UL)

When installing the chassis in a rack, be sure to implement the following Safety

instructions recommended by Underwriters Laboratories:

• Elevated Operating Ambient - If installed in a closed or multi-unit rack

assembly, the operating ambient temperature of the rack environment may be

greater than room ambient. Therefore, consideration should be given to

installing the equipment in an environment compatible with the maximum

ambient temperature (Tma) specified by the manufacturer.

• Reduced Air Flow - Installation of the equipment in a rack should be such that

the amount of air flow required for safe operation on the equipment is not

compromised.

• Mechanical Loading - Mounting of the equipment in the rack should be such

that a hazardous condition is not achieved due to uneven mechanical loading.

• Circuit Overloading - Consideration should be given to the connection of the

equipment to the supply circuit and the effect that overloading of the circuits

might have on overcurrent protection and supply wiring. Appropriate

consideration of equipment nameplate ratings should be used when addressing

this concern.

• Reliable Earthing - Reliable earthing of rack-mounted equipment should be

maintained. Particular attention should be given to supply connections other

than direct connections to the branch circuit (e.g., use of power strips.)