User`s manual

User's Manual A. MediaPack Applications
Version 2.2 165 July 2007
The procedure below describes the Fax configuration. This configuration applies to both
Unit A and Unit B.
¾ To configure the FAX parameters:
1. Complete the initial settings configuration (refer to Section 'Initial Configuration' on
page 39).
2. Configure the MediaPack ISDN-to-IP FAX settings:
• Open the 'ISDN Profiles' screen (Protocol Management menu > Profile
Definitions submenu > ISDN Profiles option).
• From the 'Fax Signaling Method' drop-down list, enable Fax data transfer protocol
by selecting either 'T.38 Relay' or 'G.711 Transport' (e.g. 'T.38 Relay').
Figure A-7: Fax Transfer Enabled (e.g., T.38 Relay)
3. Configure the MediaPack IP-to-ISDN Fax settings:
• Open the 'IP Profiles' screen (Protocol Management menu > Profile
Definitions submenu > IP Profiles option).
• From the 'Fax Signaling Method' drop-down list, select 'T.38 Relay'.