User`s manual

User's Manual A. MediaPack Applications
Version 2.2 163 July 2007
¾ To configure the MediaPack connection to the PBX:
1. Perform the initial configuration of the MediaPack’s IP interfaces and network settings
(refer to Section 'Connecting MediaPack's LAN Interface to your PC' on page 40).
2. Access the ‘ISDN Ports’ screen (Protocol Management menu > ISDN submenu >
ISDN Port Settings option).
Figure A-5: ISDN Ports Screen
3. From the 'ISDN Ports' list, select an ISDN port.
4. From the 'Uni-Side' drop-down list, select 'Net'.
5. From the 'Layer 2 Mode' drop-down list, select 'Point to Multipoint'.
6. From the 'ISDN Interface' drop-down list, select the ISDN interface to which the
configured port binds.
7. Click Submit to apply your changes.
8. To save the changes to the flash memory, refer to Section 'Saving Configuration
Settings on the MediaPack' on page 146.
9. Return to the initial settings and continue from the ISDN Interfaces configuration (refer
to Section 'Configuring the ISDN Interfaces' on page 53).
Note: Regarding the ISDN interface configuration, in the example configuration of
the PBX connection (Point to Multipoint, Net interface), the MSN
configuration is not applicable (for additional information on MSN refer to
Section 'MSN' on page 172.
A.2 Lifeline and Fallback Setup
For Lifeline and Fallback setup, refer to Section 'Connecting the Lifeline Port' on page 34
and Section 'Connecting the PSTN Fallback Port' on page 36 respectively.