User`s manual

MediaPack BRI Series
User's Manual 162 Document #: LTRT-83702
8. From the 'ISDN Interfaces' list, select the ISDN interface that is bind to the ISDN port
configured above.
9. Configure the MSN Suffix (Identical to an ISDN Phone MSN configuration). For
additional information regarding MSN, refer to Section 'MSN' on page 172.
10. Click Submit to apply your changes.
11. To save the changes to the flash memory, refer to Section 'Saving Configuration
Settings on the MediaPack' on page 146.
12. Return to the initial settings and continue the configuration of the MediaPack SIP
Parameters and routing tables (refer to Section 'Configuring the SIP Parameters' on
page 54).
Note: In this current network architecture, the MediaPack is configured
identically to an ISDN Phone device (User Interface, Point to Multipoint
connection). Therefore, the MSN configuration is required. During a call
setup, the complete destination number is verified against the MSN. As
a result, in this setup, digit-by-digit dialing towards the MediaPack is not
supported (in ISDN standard Overlap Receiving on ISDN User Side).
A.1.4 Using Point-to-Multipoint Connections, PBX Trunk Interface
A Point-to-Multipoint connection between the PBX and the MediaPack is illustrated in the
network architecture diagram below (Figure A-4). The MediaPack is connected to the
PBX’s Trunk interface. In other words, the MediaPack provides an ISDN Network and the
PBX is a User/Terminal device.
Figure A-4: Connecting to PBX using Point-to- Multipoint Connection, PBX Trunk Interface