User`s manual

MediaPack BRI Series
User's Manual 158 Document #: LTRT-83702
A.1.2 Using Point-to-Point Connections, PBX Trunk Interface
A Point-to-Point connection between the PBX and the MediaPack is illustrated in the
network architecture diagram below (Figure A-2). The MediaPack is connected to the
PBX’s Trunk interface. In other words, the MediaPack provides an ISDN Network and the
PBX is a User/Terminal device.
Figure A-2: Connecting to a PBX using Point-to-Point Connection, PBX Trunk Interface
¾ To configure the MediaPack connection to the PBX:
1. Perform the initial configuration of the MediaPack’s IP interfaces and network settings
(refer to Section 'Connecting MediaPack's LAN Interface to your PC' on page 40).
2. Access the ‘ISDN Ports’ screen (Protocol Management menu > ISDN submenu >
ISDN Port Settings option).