User`s manual

MediaPack BRI Series
User's Manual 156 Document #: LTRT-83702
The subsections below provide a detailed description of the four MediaPack-PBX
connection options:
 'Using Point-to-Point Connection, PBX Subscriber Interface' on page 156. This
configuration connects remote SIP clients to a PBX.
 'Using Point-to-Point Connections, PBX Trunk Interface' on page 158. This
configuration attaches an ISDN PBX to a VoIP network.
 'Using Point-to-Multipoint Connections, PBX Subscriber Interface' on page 160. This
configuration connects SIP clients to a PBX.
 'Using Point-to-Multipoint Connections, PBX Trunk Interface' on page 162. This
configuration connects an ISDN PBX to the VoIP network.
A.1.1 Using Point-to-Point Connection, PBX Subscriber Interface
A Point-to-Point connection between the PBX and the MediaPack is illustrated in the
network architecture diagram below (Figure A-1). The MediaPack is connected to the
PBX’s Subscriber interface. In other words, the PBX provides an ISDN Network and the
MediaPack is a User/Terminal device.
Figure A-1: Connecting to PBX using Point-to-Point Connection, PBX Subscriber Interface
¾ To configure the MediaPack connection to the PBX:
1. Perform the initial configuration of the MediaPack’s IP interfaces and network settings
(refer to Section 'Connecting MediaPack's LAN Interface to your PC' on page 40).
2. Access the ‘ISDN Ports’ screen (Protocol Management menu > ISDN submenu >
ISDN Port Settings option).