User`s manual

MediaPack BRI Series
User's Manual 154 Document #: LTRT-83702
6.7 Resetting the MediaPack
The Reset menu enables you to remotely reset the gateway. Before resetting the gateway,
you can choose to save the gateway configuration to flash memory.
¾ To reset the MediaPack:
1. On the main menu bar, click the Reset menu; the 'Reset the Device' screen is
displayed.
Figure 6-38: Reset the Device Screen
2. Select one of the following options:
• Save: current configuration is burned to flash memory prior to reset (default).
• Don’t Save: resets the MediaPack without burning the current configuration to
flash (discards all modifications to the configuration).
3. Click the Reset button. If the Save option is selected, all configuration changes are
saved to flash memory. If the Don’t Save option is selected, all configuration changes
are discarded. The MediaPack is shut down and re-activated.
Table 6-29: Resetting the Gateway using CLI
Parameter Description
reload
Resets the gateway.
Using CLI
To reset the gateway using CLI:
1. Open a CLI session using Telnet or a serial connection.
2. Log on to the system. Default username and password: user=”Admin”; password=”Admin”.
3. Type the enable command to acquire administrative privileges.
4. Change the mode to “execution”.
5. Type the following command:
Reload
6. If you want to save your changes (i.e., copy the running-configuration to the startup-configuration), type yes
at the prompt; otherwise, type no.
7. At the prompt, type yes again to restart the MediaPack; the following message is displayed: “The system is
going down".
Note: A reboot can only be performed in execution mode with administrative privileges.