User`s manual

User's Manual 6. Configuring the MediaPack
Version 2.2 145 July 2007
Table 6-26: Software Upgrade CLI Parameters
Parameter Description
copy tftp
Loads the new software using TFTP to the MediaPack.
The format is:
copy tftp://<IP address of your TFTP server>/<name of the directory in which
the new SW files are located> / <name of the download script>
Using CLI
To upgrade the MediaPack software via CLI:
1. Open a CLI session using Telnet or a serial connection.
2. Log on to the system. Default username and password: user=”Admin”; password=”Admin”.
3. Type the enable command to acquire administrative privileges.
4. Change the "execution" mode to “configuration”.
5. Use the following command: copy tftp
For example: copy tftp://10.33.2.2/mp40x_sip_2_0_17_9328/mp40x_sip_2_0_17_9328 flash.
To activate the new version (after the SW version download process completes), reset the MediaPack.
To view the downloaded SW version (after the gateway is reset), use the command show version.
Note: An upgrade procedure can only be performed in execution mode with administrative privileges.