User`s manual

User's Manual 6. Configuring the MediaPack
Version 2.2 127 July 2007
¾ To configure QoS:
1. Open the ‘QoS Profiles' screen (Advanced Configuration menu > Network Settings
> QoS Source Classes option).
Figure 6-23: QoS Source Classes Screen
2. In the Rate Limit Setting of the WAN Interface group, define the rate limit of the WAN
link in the 'Rate Limit' field.
3. Select a traffic class (e.g., local-default) that you want to configure, by selecting the
radio button corresponding to the class.
4. Configure the QoS profile according to Table 6-21.
5. Click the Modify button.
6. To save the changes to the flash memory, refer to Section 'Saving Configuration
Settings on the MediaPack' on page 146.
Table 6-21: QoS Parameters Description
Parameter Description
Rate Limit
[rate-limit <num>]
Specifies the available upstream bandwidth. This parameter is required for the
scheduler to operate correctly.
For each of the four available traffic Classes, specify the following parameters:
Name
Specifies the name of the service class to be configured.
There are 3 built in service classes
Local-voice: Locally generated RTP packets
Local-default: All other locally generated traffic
Default: Routed packets
A fourth class “user-defined” is provided.
The Access control list can be used to override local provided defaults (listed
above or to assign the “user-defined” source class