User`s manual

MediaPack BRI Series
User's Manual 124 Document #: LTRT-83702
¾ To add static routes:
1. Open the ‘Static Routing Table' screen (Advanced Configuration menu > Network
Settings > Static Routes option).
Figure 6-21: Static Routing Table Screen
2. Configure the static routes (refer to Table 6-19).
3. Click the Insert button to add the static rules.
4. To save the changes to the flash memory, refer to Section 'Saving Configuration
Settings on the MediaPack' on page 146.
To remove a static route entry, select the radio button corresponding to the static route
entry, and then click Remove. To view dynamic IP routes (i.e., Dynamic Routing Table),
click View Dynamic Routes.
Table 6-19: Static Routing Table Parameter Description
Column Name Description
Destination IP Address
Specifies the IP address of the destination host / network.
Destination Mask
Specifies the subnet mask of the destination host / network.
The address of the host / network you want to reach is determined by an AND operation that is applied on the
fields ‘Destination IP Address’ and ‘Destination Mask’.
For example:
To reach the network 10.8.x.x, enter 10.8.0.0 in the field ‘Destination IP Address’ and 255.255.0.0 in the field
‘Destination Mask’. As a result of the AND operation, the value of the last two octets in the field ‘Destination IP
Address’ is ignored.
To reach a specific host, enter its IP address in the field ‘Destination IP Address’ and 255.255.255.255 in the
field ‘Destination Mask’.
Gateway IP Address
Specifies the IP address of the router to which the packets are sent if their
destination matches the rules in the adjacent columns.
Interface
If PPPoE is used, the gateway's address is not known prior to link
establishment. You can select the WAN interface as the routing destination
instead of defining a gateway IP address.
Note: The Gateway IP Address and Interface are mutually exclusive.
Please define either a gateway IP address or an outgoing interface, not
both.
Metric
The Metric of the route.
If two equivalent routes are entered (see above), the route with the lower
metric is chosen.