User`s manual

MediaPack BRI Series
User's Manual 122 Document #: LTRT-83702
6.3.1.2 PPPoE
The PPPoE option enables you to configure the Point-to-Point Protocol over Ethernet
(PPPoE) settings.
¾ To configure the PPPoE parameters:
1. Open the ‘PPPoE' screen (Advanced Configuration menu > Network Settings >
PPPoE option).
Figure 6-20: PPPoE Screen
2. Configure the PPPoE settings according to Table 6-18.
3. Click the Submit button to save your changes.
4. To save the changes to the flash memory, refer to Section 'Saving Configuration
Settings on the MediaPack' on page 146.
Table 6-18: PPPoE Settings Parameters
Parameter Description
PPPoE Service
Defines the PPPoE service name. For most providers, no value is defined.
Username
Defines the username that the PPP uses.
Password
Defines the password that the PPP uses.
Authentication Mode
Specifies the allowed authentication options.
Valid options include:
 Pap = PPP uses Password Authentication Protocol (PAP) to authenticate
 Chap = PPP uses Challenge Handshake Authentication Protocol (CHAP)
to authenticate
 Chap pap = PPP can use PAP or CHAP to authenticate
PPPoE Service
Defines the requested PPPoE service.
By default, no service is defined.
A PPPoE Client can request a specific PPPoE service. This is used in case
mulibpe PPPoE Server are present and offer different services. In most
configurations the service filed is empty.