User`s manual

User's Manual 6. Configuring the MediaPack
Version 2.2 121 July 2007
Table 6-17: WAN and LAN IP Settings Parameters
Parameter Description
Using CLI
To change the Tel -> IP interfaces parameters:
1. Log on to the system.
2. From the main configuration mode, change to the “ip_interface” mode.
3. To enter the “ip_interface” mode use the command:
ip_interface <LAN | WAN>
4. Use the commands in square brackets ([]) to change the parameters.
Note: The media configuration is configured in the “port ethernet” mode. To enter the “port ethernet” mode, use
the command “port ethernet 0 <port num>”. Use port number “0” for the LAN interface and port number "1" for
the WAN interface.