User`s manual

MediaPack BRI Series
User's Manual 112 Document #: LTRT-83702
Table 6-14: IP Profile Parameters
Parameter Description
DTMF Transport
[dtmf-transport<in-
band|nte>]
Defines the method for transporting DTMF.
Valid options include:
 nte
 In-band = DTMF events are transported using the current voice codec.
Note: DTMF events are transported using named tone events according to RFC
2833.
RFC 2833 Payload Type
[dtmf-nte-payload-type
<payload-type>]
Defines the payload type to use for NTE. Possible values range from 96 – 127.
Default is 103.
CLEARMODE Payload
Type
[clearmode-payload-type
<payload-type>]
Defines the payload type to use for CLEARMODE. Possible values range from 96
– 127. Default is 97.
coder group
[coder-group <id>]
Defines the coder group to be used for this profile.
Using CLI
To define the IP Profile parameters:
1. Log on to the system.
2. From the main configuration mode, change to the “profile voice ip” mode.
3. To enter the “profile voice ip” mode, use the command:
profile voice ip <1..30>
The last number indicates the profile number.
4. Use the commands in square brackets ([]) to change the parameters.