User`s manual

MediaPack BRI Series
User's Manual 108 Document #: LTRT-83702
6.2.3.2 IP to Tel Routing Table
The IP to Tel Routing Table is used to route incoming IP calls to groups of channels called
ISDN interfaces. Calls are assigned to ISDN interfaces according to any combination of the
following three options (or using each independently):
 Destination phone prefix
 Source phone prefix
 Source IP address
The call is sent to the specified ISDN interface which then selects an available ISDN port.
¾ To configure the IP to Tel Routing table:
1. Open the ‘IP to Tel Routing Table’ screen (Protocol Management menu > Routing
Tables submenu > IP to Tel Routing option).
Figure 6-15: IP to Tel Routing Table Screen
2. From the ‘Position' drop-down list, select the entry that you want to add.
3. Configure the Tel to IP Routing table according to Table 6-13.
4. Click the Insert button to insert an entry at the specified position.
5. To save the changes to the flash memory, refer to Section 'Saving Configuration
Settings on the MediaPack' on page 146.
You can modify an entry by clicking the Modify button and delete an entry by clicking the
Remove button.