User`s manual

User's Manual 6. Configuring the MediaPack
Version 2.2 107 July 2007
¾ To configure the Tel to IP Routing table:
1. Open the ‘Tel to IP Routing Table’ screen (Protocol Management menu > Routing
Tables submenu > Tel to IP Routing option).
Figure 6-14: Tel to IP Routing Table Screen
2. From the ‘Position' drop-down list, select the entry that you want to edit.
3. Configure the Tel to IP Routing table according to Table 6-12.
4. Click the Insert button to insert an entry at the specified position.
5. To save the changes to the flash memory, refer to Section 'Saving Configuration
Settings on the MediaPack' on page 146.
You can modify an entry by clicking the Modify button and delete an entry by clicking the
Remove button.
Table 6-12: Tel to IP Routing Table Parameters
Parameter Description
Position
Determines the priority of the configured routing rule, where "0" has the highest
priority.
Destination Number
[dest-num-match <num>]
Match the destination number [prefix, suffix, number].
Source Number
[src-num-match <num>]
Match the source number [prefix, suffix, number].
Destination IP Address
[dest-ip <IP>]
Defines the destination IP.
Profile ID
[profile-id <id>]
Determines the profile to be used.
Using CLI
To change the Tel -> IP destination number manipulations parameters:
1. Log on to the system.
2. From the main configuration mode, change to the “routing tel2ip table” mode.
3. Enter a routing entry using the command:
pos <num> <values>
4. To remove a routing entry, use the command:
no pos <num>
For a detailed explanation of the supplied matching and manipulation criteria, use the online help.
Note 1: The key “dest-if sip” is required if Call Routing is configured using the CLI. If call routing is configured
using the Web interface, this key is implicitly added.
Note 2: <num> denotes the dialing plan notation (refer to Section 'Dialing Notations' on page 67).