User`s manual

User's Manual 6. Configuring the MediaPack
Version 2.2 103 July 2007
Figure 6-12: IP to Tel Source Number Manipulation Table
2. From the ‘Position' drop-down list, select the entry that you want to add.
3. Configure the number manipulation table according to Table 6-8.
4. Click the Insert button to insert an entry at the specified position.
5. To save the changes to the flash memory, refer to Section 'Saving Configuration
Settings on the MediaPack' on page 146.
You can modify an entry by clicking the Modify button and delete an entry by clicking the
Remove button.
Table 6-9: IP-to-Tel Source Number Manipulation Table
Parameter Description
Position
Determines the priority of the configured manipulation rule, where "0" has the
highest priority.
Destination Number
[dest-num-match <num>]
Match the destination number [prefix, suffix, number]
Source Number
[src-num-match <num>]
Match the source number [prefix, suffix, number]
Number of Stripped Digits
[strip [prefix | suffix] <num>]
Strip the number of digits at the beginning of the number. If the number is included
in parenthesis "()", this function strips the suffix. A combination of prefix and suffix
e.g. 3(2) is valid.
Prefix (Suffix) to Add
[add [prefix | suffix] <num>]
Adds this prefix or (suffix). A combination of prefix and suffix e.g. 3(2) is valid.
Number of Digits to Leave
[leave <num>]
Number of remaining digits from the right.
Using CLI
To change the IP -> Tel source number manipulations parameters:
1. Log on to the system.
2. From the main configuration mode, change to the “manipulation ip2tel src-table” mode.
3. Enter a routing entry using the command:
pos <num> <values>
4. To remove a routing entry, use the command:
no pos <num>
For a detailed explanation of the supplied matching and manipulation criteria, use the online help
Note: The table is processed downwards. The processing stops after the first
match. This means that the order is relevant.