User`s manual

User's Manual 6. Configuring the MediaPack
Version 2.2 101 July 2007
Table 6-7: IP to Tel Destination Number Manipulation Table
Parameter Description
Using CLI
To change the IP -> Tel destination number manipulations parameters:
1. Log on to the system.
2. From the main configuration mode, change to the “manipulation ip2tel dest-table” mode.
3. Enter a routing entry using the command:
pos <num> <values>
4. To remove a routing entry, use the command:
no pos <num>
For a detailed explanation of the supplied matching and manipulation criteria, use the online help
6.2.2.7 Tel-to-IP Destination Numbers
The Tel to IP Destination Number Manipulation table is used to define rules for changing
the destination number received in telephone-to-IP calls. The table is processed from top to
bottom, where the first matching rule is used to manipulate the number. Processing stops
after the first successful manipulation.
Note: For a description on the convention for entering telephone numbers in the
Manipulation tables, refer to Section 'Convention for Entering Phone
Numbers in Tables' on page 66.
¾ To configure Tel-to-IP destination numbers:
1. Open the Tel to IP Destination Number Manipulation Table (Protocol Management
menu > Manipulation Tables submenu > TelÆIP Destination Numbers option).
Figure 6-11: Tel to IP Destination Number Manipulation Table
2. From the ‘Position' drop-down list, select the entry that you want to add.
3. Configure the Number Manipulation table according to Table 6-8.
4. Click the Insert button to insert an entry at the specified position.
5. To save the changes to the flash memory, refer to Section 'Saving Configuration
Settings on the MediaPack' on page 146.
You can modify an entry by clicking the Modify button and delete an entry by clicking the
Remove button.