Installation manual

Installation Manual 48 Document #: LTRT-59813
MediaPack Series
3.6 Restoring Factory Defaults
You can use the device's hardware Reset button to restore all the device's configuration
settings to factory defaults, including the device's IP address and Web interface's login user
name and password.
Notes:
• The device resets to the software version (cmp file) saved on its flash
memory.
• For additional methods to restore default settings, refer to the User's
Manual.
¾ To restore MP-124 to factory default settings:
1. Disconnect the Ethernet cable from the device.
2. With a paper clip or any other similar pointed object, press and hold down the Reset
button (located on the front panel) for at least 12 seconds (but no more than 25
seconds); the device restores to factory default settings.
¾ To restore MP-11x to factory default settings:
1. Disconnect the Ethernet cable from the device.
2. With a paper clip or any other similar pointed object, press and hold down the Reset
button (located on the rear panel) for about six seconds; the Fail LED turns red and
the device restores to factory default settings.
3. When the Fail LED turns off, reconnect the Ethernet cable to the device.