Installation manual

Installation Manual 42 Document #: LTRT-59813
MediaPack Series
3.2 Configuring Basic SIP Parameters
Once you have completed the previous sections, you are ready to start configuring the
device using the Web interface. For information on how to fully configure the device, refer to
the device's User’s Manuals.
Tip: Once the device is configured, backup your settings by saving the
configuration (ini) file to your PC. This saved file can later be used, if
necessary, to restore configuration settings (refer to 'Backing Up and
Restoring Configuration' on page 47).
¾ To configure basic SIP parameters:
1. Access the Web interface.
2. Select the voice coders used by the device that best suits your VoIP network, in the
'Coders Table' page (Configuration tab > VoIP menu > Coders And Profiles
submenu > Coders).
3. When operating with a Proxy server, perform the following (otherwise, skip to Step 4):
a. In the 'Proxy & Registration' page (Configuration tab > VoIP menu > SIP
Definitions submenu > Proxy & Registration):
♦ Set the ‘Use Default Proxy’ field to "Yes".
♦ (Optional) In the ‘Proxy Name’ field, enter the Proxy's name. The Proxy
name replaces the Proxy IP address in all SIP messages. This means that
messages are still sent to the physical Proxy IP address, but the SIP URI
contains the Proxy name instead.
♦ To enable the device to register to a Proxy/Registrar server (at power up and
every user-defined interval - ‘Registration Time’ parameter), set the ‘Enable
Registration’ parameter to "Enable".
b. In the 'Proxy Sets Table' page (Configuration tab > VoIP menu > Control
Network submenu > Proxy Sets Table), define the IP address(s) of the Proxy
server(s). When no Proxy is used, the internal routing table is used to route the
calls.
4. Enable the device's endpoints in the 'Endpoint Phone Number Table' page
(Configuration tab > VoIP menu > GW and IP to IP submenu > Hunt Group
submenu > Endpoint Phone Number).
5. If a Proxy server is not implemented, map outgoing calls to IP addresses in the
‘Outbound IP Routing Table’ page (Configuration tab > VoIP menu > GW and IP to
IP submenu > Routing submenu > Tel to IP Routing).
6. Save your settings to the flash memory and reset the device (refer to 'Saving and
Resetting the Device' on page 44).