Installation manual

Installation Manual 38 Document #: LTRT-59813
MediaPack Series
8. In the ‘Gateway’ field, enter the IP address of the default gateway (if any).
9. Click Apply to save the new client.
10. Click OK; the ‘Client Configuration’ screen closes.
11. Physically reset the device using the hardware reset button (or power down and then
power up the device). This causes the device to use BootP; the device changes its
network parameters to the values provided by BootP.
Figure 3-2: BootP Client Configuration Screen
3.1.3 Assigning an IP Address Using Voice Menu Guidance
Initial configuration of the device can be performed using a standard touch-tone telephone
connected to one of the FXS ports. The voice menu can also be used to query and modify
basic configuration parameters.
Note: The Voice menu is automatically disabled after the administrator password is
set to a value other than the default ("Admin").
¾ To assign an IP address using the voice menu guidance:
1. Connect a telephone to one of the FXS ports.
2. Lift the handset and dial ***12345 (three stars followed by the digits 1, 2, 3, 4, and 5).
3. Wait for the 'configuration menu' voice prompt to be played.
4. To change the IP address:
a. Press 1 followed by the pound key (#); The current IP address of the device is
played.
b. Press the # key.