User`s manual

MediaPack SIP User’s Manual F. Regulatory Information
Version 4.6 293 June 2005
Safety Notice
Installation and service of this unit must only be performed by authorized, qualified service personnel.
The protective earth terminal on the back of the MP-11x/FXS must be permanently connected to protective earth.
Telecommunication Safety
The safety status of each port on the gateway is declared and detailed in the table below:
Ports Safety Status
Ethernet (100 Base-TX) SELV
FXS (ODP P/N’s)
FXS
TNV-3
TNV-2
TNV-3: Circuit whose normal operating voltages exceeds the limits for an SELV circuit under normal operating
conditions and on which over voltages from Telecommunication Networks are possible
SELV: Safety extra low voltage circuit.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Original
printed on
recycled paper
and available on
CD or Web site