User`s manual

MediaPack SIP
MediaPack SIP User’s Manual 282 Document #: LTRT-65405
Table E-2: acBoardEvResettingBoard Alarm Trap
Alarm Text:
User resetting board
Status Changes:
Condition: When a soft reset is triggered via the Web interface or SNMP.
Alarm status: Critical
Condition: After raise
Alarm status: Status stays critical until reboot. A clear trap is not sent.
Corrective Action: A network administrator has taken action to reset the device. No corrective action is
required.
Table E-3: acBoardCallResourcesAlarm Alarm Trap
Alarm:
acBoardCallResourcesAlarm
OID:
1.3.6.1.4.1.5003.9.10.1.21.2.0.8
Default Severity
Major
Event Type:
processingErrorAlarm
Probable Cause:
softwareError (46)
Alarm Text:
Call resources alarm
Status Changes:
Condition: Number of free channels exceeds the predefined RAI high threshold.
Alarm Status: Major
Note: To enable this alarm the RAI mechanism must be activated (EnableRAI = 1).
Condition: Number of free channels falls below the predefined RAI low threshold.
Alarm Status: Cleared
Table E-4: acBoardControllerFailureAlarm Alarm Trap
Alarm:
acBoardControllerFailureAlarm
OID:
1.3.6.1.4.1.5003.9.10.1.21.2.0.9
Default Severity
Minor
Event Type:
processingErrorAlarm
Probable Cause:
softwareError (46)
Alarm Text:
Controller failure alarm
Status Changes:
Condition: Proxy has not been found
Alarm Status: Major
Additional Info: Proxy not found. Use internal routing
or
Proxy lost. looking for another Proxy
Condition: Proxy is found.
The clear message includes the IP address of the located Proxy.
Alarm Status: Cleared