User`s manual

MediaPack SIP
MediaPack SIP User’s Manual 234 Document #: LTRT-65405
snmpTargetMIB.
¾ To add a read-only community string (v2user):
• Add a new row to the srCommunityTable with CommunityName v2user and GroupName
ReadGroup.
¾ To delete the read-only community string (v2user), take these 2 steps:
1. If v2user is being used as the trap community string, follow the procedure for changing the
trap community string (see below).
2. Delete the srCommunityTable row with CommunityName v2user.
¾ To add a read-write community string (v2admin):
• Add a new row to the srCommunityTable with CommunityName of v2admin and GroupName
ReadWriteGroup.
¾ To delete the read-write community string (v2admin), take these 2
steps:
1. If v2admin is being used as the trap community string, follow the procedure for changing the
trap community string. (See below.)
2. Delete the srCommunityTable row with a CommunityName of v2admin and GroupName of
ReadWriteGroup.
¾ To change the only read-write community string from v2admin to
v2mgr, take these 4 steps:
1. Follow the procedure above to add a read-write community string to a row for v2mgr.
2. Set up the EM so that subsequent ‘set’ requests use the new community string, v2mgr.
3. If v2admin is being used as the trap community string, follow the procedure to change the
trap community string (see below).
4. Follow the procedure above to delete a read-write community name in the row for v2admin.
¾ To change the trap community string, take these 2 steps:
(The following procedure assumes that a row already exists in the srCommunityTable for the new
trap community string. The trap community string can be part of the TrapGroup, ReadGroup or
ReadWriteGroup. If the trap community string is used solely for sending traps (recommended), it
should be made part of the TrapGroup).
1. Add a row to the vacmSecurityToGroupTable with these values: SecurityModel=2,
SecurityName=the new trap community string, GroupName=TrapGroup, ReadGroup or
ReadWriteGroup. The SecurityModel and SecurityName objects are row indices.
Note: You must add GroupName and RowStatus on the same set.
2. Modify the SecurityName field in the sole row of the snmpTargetParamsTable.