User`s manual

MediaPack SIP User’s Manual 14. Embedded Command Line Interface
Version 4.6 225 June 2005
14.2.1 Changing the Networking Parameters
You can use the CLI to change the network settings (IP address, subnet mask and default
gateway IP address) of the MediaPack.
¾ To change the network settings via the CLI, take these 4 steps:
1. At the prompt type ‘conf’ and press enter; the configuration folder is accessed.
2. To check the current network parameters, at the prompt, type ‘GCP IP’ and press enter; the
current network settings are displayed.
3. Change the network settings by typing: ‘SCP IP [ip_address] [subnet_mask]
[default_gateway]’ (e.g., ‘SCP IP 10.13.77.7 255.255.0.0 10.13.0.1’); the new settings take
effect on-the-fly. Connectivity is active at the new IP address.
Note: This command requires you to enter all three network parameters (each separated by
a space).
4. To save the configuration, at the prompt, type ‘SAR’ and press enter; the MediaPack restarts
with the new network settings.