User`s manual
MediaPack SIP
MediaPack SIP User’s Manual 218 Document #: LTRT-65405
3. Record and retain the IP address, port number and ’shared secret’ used by the RADIUS
server.
4. Configure the MP-11x relevant parameters according to Section
12.2.2 below.
12.2.2 Configuring RADIUS Support
For information on the RADIUS parameters, refer to Table 5-36 on page 127.
¾ To configure RADIUS support on the MP-11x via the Embedded Web
Server, take these 8 steps:
1. Access the Embedded Web Server (refer to Section 5.3 on page 48).
2. Open the ‘Security Settings’ screen (Advanced Configuration menu > Network Settings >
Security Settings option); the ‘Security Settings’ screen is displayed.
3. Under section ‘RADIUS Settings’, in the field ‘Enable RADIUS Access Control’, select
‘Enable’; the RADIUS application is enabled.
4. In the field ‘Use RADIUS for Web / Telnet Login’, select ‘Enable’; RADIUS authentication is
enabled for Web and Telnet login.
5. Enter the RADIUS server IP address, port number and shared secret in the relevant fields.
6. In the field ‘Require Secured Web Connection (HTTPS)’, select ‘HTTPS only’.
It is important you use HTTPS (secure Web server) when connecting to the gateway over an
open network, since the password is transmitted in clear text. Similarly, for Telnet, use SSL
‘TelnetServerEnable = 2 (refer to Section
12.1 on page 213).
7. To save the changes so they are available after a power fail, refer to refer to Section
5.9 on
page 161.
8. Reset the gateway. Click the Reset button on the main menu bar; the Reset screen is
displayed. Click the button Reset.
After reset, when accessing the Web or Telnet servers, use the username and password you
configured in the RADIUS database. The local system password is still active and is used when
the RADIUS server is down.
¾ To configure RADIUS support on the MP-11x using the ini file:
• Add the following parameters to the ini file. For information on modifying the ini file, refer to
Section
6.2 on page 163.
¾ EnableRADIUS = 1
¾ WebRADIUSLogin = 1
¾ RADIUSAuthServerIP = IP address of RADIUS server
¾ RADIUSAuthPort = port number of RADIUS server, usually 1812
¾ SharedSecret = your shared secret'
¾ HTTPSOnly = 1