User`s manual

MediaPack SIP
MediaPack SIP User’s Manual 190 Document #: LTRT-65405
8.11.4.2 Dialing from other PBX line, or from PSTN
¾ To configure the call, take these 5 steps:
1. Dial the PBX subscriber number the same way as if the user’s phone was connected directly
to PBX.
2. Immediately as PBX rings into FXO MediaPack, the ring signal is ‘send’ to phone connected
to FXS MediaPack.
3. Once the phone’s handset, connected to FXS MediaPack, is raised, the FXO MediaPack
seizes the PBX line and the voice path is established between the phone and the PBX line.
4. There is a one to one mapping between PBX lines and FXS MediaPack ports. Each PBX line
is routed to the same phone (connected to FXS MediaPack).
5. The call is disconnected when phone connected to FXS MediaPack goes onhook.
8.11.4.3 FXS MediaPack Configuration (using the Embedded Web Server)
¾ To configure the FXS MediaPack, take these 3 steps:
1. In the ‘Endpoint Phone Numbers’ screen, assign the phone numbers 100 to 107 for the
gateway’s endpoints.
2. In the ‘Automatic Dialing’ screen, enter the phone numbers of the FXO MediaPack gateway
in the ‘Destination Phone Number’ fields. When a phone connected to port #1 goes offhook,
the FXS gateway automatically dials the number ‘200’.
3. In the ‘Tel to IP Routing’ screen, enter 20 in the ‘Destination Phone Prefix’ field, and the IP
address of the FXO MediaPack gateway (10.1.10.2) in the field ‘IP Address’.