User`s manual

MediaPack SIP
MediaPack SIP User’s Manual 140 Document #: LTRT-65405
Table 5-42: Channel Settings, RTP Parameters
Parameter Description
Basic RTP Packet Interval
[BasicRTPPacketInterval]
Note: This parameter should not be
used. Use the ‘Coders’ screen under
‘Protocol Definition’ instead.
N/A.
Controlled internally by the gateway according to the selected coder.
RTP Directional Control
[RTPDirectionControl]
N/A.
Controlled internally by the gateway according to the selected coder.
RFC 2833 TX Payload Type
[RFC2833TxPayloadType]
N/A.
Use the ini file parameter RFC2833PayloadType instead.
RFC 2833 RX Payload Type
[RFC2833RxPayloadType]
N/A.
Use the ini file parameter RFC2833PayloadType instead.
RFC 2198 Payload Type
[RFC2198PayloadType]
RTP redundancy packet payload type, according to RFC 2198.
The range is 96-127. The default is 104.
Applicable if ‘RTP Redundancy Depth=1’
Fax Bypass Payload Type
[FaxBypassPayloadType]
Determines the fax bypass RTP dynamic payload type.
The valid range is 96 to 120. The default value is 102.
Enable RFC 3389 CN Payload Type
[EnableStandardSIDPayloadType]
Determines whether Silence Indicator (SID) packets that are sent and received
are according to RFC 3389.
Disable [0] = G.711 SID packets are sent in a proprietary method (default).
Enable [1] = SID (comfort noise) packets are sent with the RTP SID payload
type according to RFC 3389. Applicable to G.711 and G.726 coders.
Analog Signal Transport Type
[AnalogSignalTransportType]
Ignore analog signals [0] = Hook-flash isn’t transferred to the remote side
(default).
RFC 2833 analog signal relay [1] = Hook-flash is transferred via RFC 2833.