User`s manual

MediaPack SIP
MediaPack SIP User’s Manual 136 Document #: LTRT-65405
5.6.2.2 Configuring the Fax / Modem / CID Settings
¾ To configure the Fax / Modem / CID Settings parameters, take these 4
steps:
1. Open the ‘Fax / Modem / CID Settings’ screen (Advanced Configuration menu > Channel
Settings > Fax / Modem / CID Settings option); the ‘Fax / Modem / CID Settings’ screen is
displayed.
Figure 5-37: Fax / Modem / CID Settings Screen
2. Configure the Fax / Modem / CID Settings according to Table
5-41.
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section
5.9 on page
161.
Table
5-41: Channel Settings, Fax/Modem/CID Parameters (continues on pages 136 to 138)
Parameter Description
Fax Transport Mode
[FaxTransportMode]
Fax Transport Mode that the gateway uses.
You can select:
Disable [0].
T.38 Relay [1] (default).
Bypass [2].
Events Only [3].
Note: If parameter IsFaxUsed = 1, then FaxTransportMode is always set to 1
(T.38 relay).
Caller ID Transport Type
[CallerIDTransportType]
N/A.