User`s manual

MediaPack SIP
MediaPack SIP User’s Manual 134 Document #: LTRT-65405
5.6.2 Configuring the Channel Settings
From the Channel Settings page you can define:
• Voice Settings (refer to Section
5.6.2.1 below).
• Fax / Modem / CID Settings (refer to Section
5.6.2.2 on page 136).
• RTP Settings (refer to Section
5.6.2.3 on page 139).
• Hook-Flash Settings (refer to Section
5.6.2.4 on page 141).
These parameters are applied to all MediaPack channels.
Note that several Channels Settings parameters can be configured per call using profiles (refer to
Section
5.5.5 on page 91).
Note 1: Those parameters contained within square brackets are the names used to
configure the parameters via the ini file.
Note 2: Channel parameters are changeable on-the-fly. Changes take effect from
next call.
5.6.2.1 Configuring the Voice Settings
¾ To configure the Voice Settings parameters, take these 4 steps:
1. Open the ‘Voice Settings’ screen (Advanced Configuration menu > Channel Settings >
Voice Settings option); the ‘Voice Settings’ screen is displayed.
Figure 5-36: Voice Settings Screen
2. Configure the Voice Settings according to Table
5-40.
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section
5.9 on page
161.