User`s manual

MediaPack SIP User’s Manual 5. Configuring the MediaPack
Version 4.6 129 June 2005
Table 5-37: Board, ini File Parameters (continues on pages 128 to 131)
ini File Parameter Name Valid Range and Description
ResetWebPassword
Resets the Administrator and Monitoring username and password to their
defaults.
0 = Password and username retain their values (default).
1 = Password and username are reset to:
Administrator:
Default username ‘Admin’.
Default password ‘Admin’.
Monitoring:
Default username ‘User’.
Default password ‘User’.
DisableWebConfig
0 = Enable changing parameters from Web (default)
1 = Operate Web server in ‘read only’ mode
HTTPport
HTTP port used for Web management (default = 80)
EthernetPhyConfiguration
0 = 10 Base-T half-duplex.
1 = 10 Base-T full-duplex.
2 = 100 Base-TX half-duplex.
3 = 100 Base-TX full-duplex.
4 = Auto-Negotiate (default).
For detailed information on Ethernet interface configuration, refer to Section
9.1
on page 193.
DisableNAT
Enables / disables the Network Address Translation (NAT) mechanism.
0 = Enabled.
1 = Disabled (default).
Note: The compare operation that is performed on the IP address is enabled
by default and is controlled by the parameter ‘EnableIPAddrTranslation’. The
compare operation that is performed on the UDP port is disabled by default and
is controlled by the parameter ‘EnableUDPPortTranslation’.
EnableIPAddrTranslation
0 = Disable IP address translation.
1 = Enable IP address translation for RTP and T.38 packets (default).
When enabled, the gateway compares the source IP address of the first
incoming packet, to the remote IP address stated in the opening of the channel.
If the two IP addresses don’t match, the NAT mechanism is activated.
Consequently, the remote IP address of the outgoing stream is replaced by the
source IP address of the first incoming packet.
Note: The NAT mechanism must be enabled for this parameter to take effect
(DisableNAT = 0).
EnableUDPPortTranslation
0 = Disable UDP port translation (default).
1 = Enable UDP port translation.
When enabled, the gateway compares the source UDP port of the first
incoming packet, to the remote UDP port stated in the opening of the channel.
If the two UDP ports don’t match, the NAT mechanism is activated.
Consequently, the remote UDP port of the outgoing stream is replaced by the
source UDP port of the first incoming packet.
Note: The NAT mechanism and the IP address translation must be enabled for
this parameter to take effect (DisableNAT = 0, EnableIpAddrTranslation = 1).
HeartBeatDestIP
Destination IP address (in dotted format notation) to which the gateway sends
proprietary UDP ‘ping’ packets.
The default IP address is 0.0.0.0.
HeartBeatDestPort
Destination UDP port to which the heartbeat packets are sent.
The range is 0 to 64000.
The default is 0.
HeartBeatIntervalmsec
Delay (in msec) between consecutive heartbeat packets.
10 = 100000.
-1 = disabled (default).
RADIUSRetransmission
Determines the number of RADIUS retransmission retries for the same request
(MP-11x only).
The valid range is 1 to 10.
The default value is 3.