User`s manual

MediaPack SIP
MediaPack SIP User’s Manual 128 Document #: LTRT-65405
Table 5-36: Network Settings, Security Settings Parameters
Parameter Description
RADIUSAuthServerIP
[RADIUS Authentication Server
IP Address]
IP address of the RADIUS authentication server.
RADIUSAuthPort
[RADIUS Authentication Server
Port]
Port number of the RADIUS authentication server.
The default value is 1645.
SharedSecret
[RADIUS Shared Secret]
‘Secret’ used to authenticate the gateway to the RADIUS server. Should be a
cryptographically strong password.
5.6.1.10 Advanced Configuration ini File Parameters
Table 5-37 describes the board parameters that can only be configured via the ini file.
Table
5-37: Board, ini File Parameters (continues on pages 128 to 131)
ini File Parameter Name Valid Range and Description
LifeLineType
The Lifeline is activated on:
0 = Power down (default)
1 = Power down or when link is down (physical disconnect)
2 = Power down or when link is down or on network failure (logical link
disconnect)
Note: To enable Lifeline switching on network failure, LAN watch dog must be
activated (EnableLANWatchDog=1).
DSPVersionTemplateNumber
0 = Firmware DSP version supports PCM/ADPCM, G.723 and G.729A/B
Coders.
1 = Firmware DSP version supports PCM/ADPCM.
2 = Same as ‘0’ but with voice and energy detectors (default).
3 = Same as ‘1’ but with voice and energy detectors.
Usually DSP templates 2 or 3 should be used. These templates are required
for the FXO gateway Answer and Disconnect supervision features.
EnableDiagnostics
Tests the correct functionality of the different hardware components on the
gateway. On completion of the test, the gateway sends information on the test
results of each hardware component to the Syslog server.
0 = No diagnostics (default).
1 = Performs diagnostics. Full test of DSPs, PCM, Switch, LAN, PHY and
Flash.
2 = Performs diagnostics. Full test of DSPs, PCM, Switch, LAN, PHY, but
partial test of Flash (a quicker mode).
For detailed information, refer to Section 13.1 on page 221.
EnableParametersMonitoring
Enables to view changes made on-the-fly to parameters via Web or SNMP.
0 = Deactivate (default).
1 = Activate.
WatchDogStatus
0 = Disable gateway’s watch dog.
1 = Enable gateway’s watch dog (default).
DisableRS232
0 = RS-232 serial port is enabled (default).
1 = RS-232 serial port is disabled.
The RS-232 serial port can be used to access the CLI (Section
14 on page
223) and to view error / notification messages.
For information on establishing a serial communications link with the
MediaPack, refer to Section
10.2 on page 201).
DisableWebTask
0 = Enable Web management (default)
1 = Disable Web management