User`s manual

MediaPack SIP User’s Manual 5. Configuring the MediaPack
Version 4.6 127 June 2005
5.6.1.9 Configuring the Security Settings (MP-11x Only)
Use the Security Settings screen to set the secured Web access parameters (HTTPS) (for
detailed information refer to Section
12.1.2 on page 213), and to configure the RADIUS
authentication parameters (for detailed information refer to Section
12.2 on page 217).
¾ To configure the Security Settings parameters, take these 4 steps:
1. Open the ‘Security Settings’ screen (Advanced Configuration menu > Network Settings >
Security Settings option); the ‘Security Settings’ screen is displayed.
Figure 5-35: Security Settings Screen
2. Configure the Security Settings according to Table
5-36.
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section
5.9 on page
161.
Table 5-36: Network Settings, Security Settings Parameters
Parameter Description
Secured Web Connection
[HTTPSOnly]
Determines the protocol types used to access the Embedded Web Server.
HTTP and HTTPS [0] (default).
HTTPS only [1] (unencrypted HTTP packets are blocked).
RADIUS Settings
EnableRADIUS
[Enable RADIUS Access Control]
Enables / disables the RADIUS application.
Disable [0] = RADIUS application is disabled (default).
Enable [1] = RADIUS application is enabled.
Note: In the current version RADIUS is used only for HTTP authentication (CDR
over RADIUS isn’t supported).
WebRADIUSLogin
[Use RADIUS for Web/Telnet
Login]
Uses RADIUS queries for Web and Telnet interface authentication.
Disable [0] (default).
Enable [1].
When enabled, logging to the gateway’s Web and Telnet embedded servers is
performed via a RADIUS server. The gateway contacts a predefined server and
verifies the given username and password pair against a remote database, in a
secure manner.
Note 1: The parameter ‘EnableRADIUS’ must be set to 1.
Note 2: RADIUS authentication requires HTTP basic authentication, meaning the
username and password are transmitted in clear text over the network. Therefore,
users are recommended to set the parameter ‘HttpsOnly = 1’ to force the use of
HTTPS, since the transport is encrypted.