Installation guide

MP-11x
MP-11x 36 Document #: LTRT-61504
Telecommunication Safety
The safety status of each port on the gateway is declared and detailed in the table below:
Ports Safety Status
Ethernet (100 Base-TX) SELV
FXS (ODP P/N’s)
FXS
TNV-3
TNV-2
TNV-3: Circuit whose normal operating voltages exceeds the limits for an SELV circuit under normal
operating conditions and on which over voltages from Telecommunication Networks are possible
SELV: Safety extra low voltage circuit.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
Original
printed on
recycled paper
and available on
CD or Web site