Installation guide

MP-11x
MP-11x 34 Document #: LTRT-61504
Figure 7-8: Auxiliary Files Screen
¾ To save the loaded auxiliary files to flash memory, take these 2 steps:
1. Click the Save Configuration button on the main menu bar; the ‘Save Configuration to the
Flash Memory’ screen is displayed.
Note: Saving an auxiliary file to flash memory may disrupt traffic on the device. To
avoid this, disable all traffic on the device before saving to flash memory.
2. Click the Save Configuration button in the middle of the screen; a confirmation message
appears when the save is complete.
Note: A device reset is required to activate a loaded CPT file, and may be required
for the activation of certain ini file parameters.
¾ To reset the MP-11x, take these 2 steps:
1. Click the Reset button on the main menu bar; the ‘Reset’ screen is displayed.
2. Click the Reset button in the middle of the screen; the auxiliary files are saved into flash and
the MP-11x restarts. This takes approximately 2 minutes to complete. When the MP-11x has
finished restarting, the Power and Ready LEDs on the front panel are lit green.