Installation guide

Fast Track Installation Guide 3. Configuring the MP-11x
Version 4.6 17 July 2005
3.3 Accessing the Embedded Web Server
¾ To access the Embedded Web Server, take these 4 steps:
1. Open a standard Web-browsing application such as Microsoft™ Internet Explorer™ (Version
6.0 and higher) or Netscape™ Navigator™ (Version 7.2 and higher).
2. In the URL field, specify the IP address of the MP-11x (e.g., http://10.1.10.10); the
Embedded Web Server’s ‘Enter Network Password’ screen appears, shown in Figure
3-2.
Figure
3-2: Embedded Web Server Login Screen
3. In the ‘User Name’ and ‘Password’ fields, enter the username (default: “Admin”) and
password (default: “Admin”). Note that the username and password are case-sensitive.
4. Click OK; the ‘Quick Setup’ screen is accessed, shown in Figure
3-3 (MGCP), Figure 3-4
(H.323), and Figure
3-5 (SIP).
3.4 Configuring the MP-11x Basic Control Protocol
Parameters
To configure the MP-11x basic control protocol parameters use the Embedded Web Server’s
‘Quick Setup’ screen.
• For MGCP refer to Section
3.4.1 on page 17.
• For H.323, refer to Section
3.4.2 on page 19.
• For SIP, refer to Section
3.4.3 on page 21.
When you have completed the above relevant section you are then ready to start using the MP-
11x. For information on how to fully configure the VoIP gateway, refer to the MP-11x User’s
Manuals.
Tip: Once the gateway is configured correctly, back up your settings by making a
copy of the VoIP gateway configuration (ini file) and store it in a directory on
your PC. This saved file can be used to restore configuration settings at a
future time. For information on backing up and restoring the gateway’s
configuration refer to Section 5 on page 25.
Note: The following configuring Sections from here up to and including Section
3.4.3 on page 21 apply individually to MGCP, H.323, or SIP.
MGCP configuring continues with Section 3.4.1 on page 17.
H.323 configuring continues with Section 3.4.2 on page 19.
SIP configuring continues with Section 3.4.3 on page 21.