Installation guide

Fast Track Installation Guide 3. Configuring the MP-11x
Version 4.6 15 July 2005
11. Click OK; the ‘Client Configuration’ screen is closed.
12. Use the reset button (located on the MP-11x rear panel) to physically reset the gateway
causing it to use BootP; the device changes its network parameters to the values provided
by the BootP.
Figure
3-1: Client Configuration Screen with Blank Parameters
3.1.3 Assigning an IP Address Using the CLI
First access the CLI using a standard Telnet application or using a serial communication software
(e.g., HyperTerminal
TM
) connected to the MP-11x RS-232 port (refer to Section 3.1.3.1 below).
Then assign the MP-11x an IP address (refer to Section
3.1.3.2 on page 16).
3.1.3.1 Access the CLI
¾ To access the CLI via the Embedded Telnet Server, take these 3 steps:
1. Enable the Embedded Telnet Server:
¾ Access the MP-11x Embedded Web Server (refer to Section
3.3 on page 17).
¾ Set the parameter ‘Embedded Telnet Server’ (under Advanced Configuration >
Network Settings > Application Settings) to ‘Enable (Unsecured)’ or ‘Enable Secured
(SSL)’.
¾ Click the Reset button on the main menu bar; the Reset screen is displayed.
¾ Click the Reset button in the middle of the Reset screen with the Burn option selected;
the MP-11x is shut down and re-activated. A message about the waiting period is
displayed. The screen is refreshed.
2. Use a standard Telnet application to connect to the MP-11x Embedded Telnet Server. Note
that if the Telnet server is set to SSL mode, a special Telnet client is required on your PC to
connect to the Telnet interface over a secured connection.
3. Login using the username (‘Admin’) and password (‘Admin’).