User`s manual

Mediant 2000 & TP-1610 & TP-260
SIP User's Manual 86 Document #: LTRT-68805
¾ To modify an existing remote NFS file system, take these 4 steps:
1. Click the Edit radio button for the row to be modified.
2. Change the values on the selected row according to your requirements.
3. Click the Apply New Settings button; the remote NFS file system is mounted using
the new settings. Check the Syslog server for the ‘NFS mount was successful’
message.
4. To save the changes so they are available after a power fail, refer to Section 5.9.2 on
page 124.
Figure
5-20 below shows an example of an NFS table definition via ini file using parameter
tables (for information on parameter tables, refer to Section
11.5 on page 253).
Figure 5-20: NFS ini File Example
[ NFSServers ]
FORMAT NFSServers_Index = NFSServers_HostOrIP, NFSServers_RootPath,
NFSServers_NfsVersion, NFSServers_AuthType, NFSServers_UID, NFSServers_GID,
NFSServers_VlanType;
NFSServers 1 = 101.1.13, /audio1, 3, 1, 0, 1, 1;
[ \NFSServers ]
5.6.1.2 Configuring the IP Routing Table
The IP routing table is used by the gateway to determine IP routing rules. It can be used,
for example, to define static routing rules for the OAM and Control networks since a default
gateway isn’t supported for these networks (refer to Section
9.10.1 on page 237). Before
sending an IP packet, the gateway searches this table for an entry that matches the
requested destination host / network. If such entry is found, the gateway sends the packet
to the indicated router. If no explicit entry is found, the packet is sent to the default gateway
(configured in Network Settings>IP Settings screen). Up to 50 routing entries are available.
¾ To configure the IP Routing table, take these 3 steps:
1. Open the ‘IP Routing Table’ screen (Advanced Configuration menu > Network
Settings > IP Routing Table option); the ‘IP Routing Table’ screen is displayed.
Figure 1-3: IP Routing Table Screen
2. Use the ‘Add a new table entry’ pane to add a new routing rule. Each field in the IP
routing table is described in Table 5-10.
3. Click the button Add New Entry; the new routing rule is added to the IP routing table.