User`s manual

SIP User's Manual 5. Web Management
Version 5.0 81 October 2006
Figure 5-16: IP Profile Settings Screen
2. In the ‘Profile ID’ drop-down list, select the IP Profile you want to edit (up to four IP
Profiles can be configured).
3. In the ‘Profile Preference’ drop-down list, select the preference (1-10) of the current
Profile. The preference option is used to determine the priority of the Profile. Where
‘20’ is the highest preference value. If both IP and Tel profiles apply to the same call,
the coders and other common parameters (noted by an asterisk in the description of
the parameter lPProfile_ID) of the preferred Profile are applied to that call. If the
Preference of the Tel and IP Profiles is identical, the Tel Profile parameters are
applied.
Note: If the coder lists of both IP and Tel Profiles apply to the same call, an
intersection of the coders is performed (i.e., only common coders remain). The order
of the coders is determined by the preference.
4. Configure the Profile’s parameters according to your requirements. For detailed
information on each parameter refer to the description of the screen in which it is
configured as an individual parameter.
5. In the ‘Coder Group’ drop-down list, select the coder group you want to assign to that
Profile. You can select the gateway’s default coders (refer to Section 5.5.1.1 on page
63) or one of the coder groups you defined in the Coder Group Settings screen (refer
to Section 5.5.6.1 on page 78).
6. Repeat steps 2 to 6 for the second to fifth IP Profiles (optional).
7. Click the Submit button to save your changes.
8. To save the changes so they are available after a power fail, refer to Section 5.9.2 on
page 124.