User`s manual

Mediant 2000 & TP-1610 & TP-260
SIP User's Manual 52 Document #: LTRT-68805
¾ To access the CLI via the RS-232 port, take these 2 steps:
1. Connect the RS-232 port to your PC (For the Mediant 2000, refer to Section 3.1.4.3 on
page 41.
2. Use serial communication software (e.g., HyperTerminal
TM
) to connect to the Mediant
2000.
Set your serial communication software to the following communications port settings:
• Baud Rate: 115,200 bps
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
The CLI prompt becomes available.
4.2.3.2 Assign an IP Address
¾ To assign an IP address via the CLI, take these 4 steps:
1. At the prompt type conf, and then press Enter; the configuration folder is accessed.
2. To check the current network parameters, at the prompt, type GCP IP, and then press
Enter; the current network settings are displayed.
3. Change the network settings by typing:
SCP IP [ip_address] [subnet_mask] [default_gateway]
(e.g., ‘SCP IP 10.13.77.7 255.255.0.0 10.13.0.1’); the new settings take effect on-the-
fly. Connectivity is active at the new IP address.
Note: This command requires you to enter all three network parameters (each
separated by a space).
4. To save the configuration, at the prompt, type SAR, and then press Enter; the
Mediant 2000 restarts with the new network settings.