User`s manual

SIP User's Manual 3. Installation
Version 5.0 45 October 2006
Notes:
• Before removing or inserting boards from / to the chassis, attach a wrist
strap for electrostatic discharge (ESD) and connect it to the rack frame
using an alligator clip.
• Do not set components down without protecting them with a static bag.
3.2.3.1 Inserting Boards
¾ To insert the TP-1610 board into the chassis, take these 3 steps:
1. Choose an available slot in a compactPCI™ chassis and gently insert the TP-1610
board into it; as the TP-1610 board is inserted, the black plastic handles, at both ends
of the board’s front panel, must engage with the chassis. When the TP-1610 board is
firmly mounted into the correct position inside the chassis, the red plastic latches
within each handle self-lock (this also ensures that the TP-1610 board is properly
earthed via the chassis) and the blue hot-swap LED is lit.
2. Wait for the blue hot-swap LED to turn off, indicating that the board has been inserted
correctly and the power supply is functioning correctly.
3. Fasten the screws on the front panel of the board to secure the board to the chassis.
¾ To insert the TP-1610 RTM into the chassis, take these 2 steps:
1. Choose an available slot in a compactPCI™ chassis and gently insert the TP-1610
RTM into it; as the TP-1610 RTM is inserted, the black plastic handles, at both ends of
the board’s panel, must engage with the chassis. When the TP-1610 RTM is firmly
mounted into the correct position inside the chassis, the red plastic latches within each
handle self-lock (this also ensures that the TP-1610 board is properly earthed via the
chassis).
2. Fasten the screws on the front panel of the board to secure the board to the chassis.
3.2.3.2 Removing Boards
¾ To remove the TP-1610 board from the chassis, take these 3 steps:
1. Unfasten the screws on the plate of the board.
2. Press the red ejector buttons on the two black ejector/injector latches on both ends
and wait for the hot-swap blue LED to light, indicating that the board can be removed.
3. Pull on the two ejector/injector latches and ease out the board from the slot.
¾ To remove the TP-1610 RTM from the chassis, take these 4 steps:
1. Remove the cables attached to the RTM.
2. Unfasten the screws on the brackets at both ends of the panel that secure the RTM to
the chassis.
3. Press the red ejector buttons on the two black ejector/injector latches on both ends.
4. Grasp the panel and ease the RTM board out of the slot.
3.2.4 Cabling the TP-1610
¾ To cable the TP-1610, take these 3 steps:
1. Connect the E1/T1 trunk interfaces (refer to Section 3.1.4.1 on page 40).
2. Install the Ethernet connection (refer to Section 3.1.4.2 on page 41).
3. Optionally, connect the TP-1610 RS-232 port to your PC (refer to Section 3.1.4.3 on
page 41).