User`s manual

SIP User's Manual K. Regulatory Information
Version 5.0 403 October 2006
Industry Canada Notice
This equipment meets the applicable Industry Canada Terminal Equipment technical specifications. This is confirmed by
the registration numbers. The abbreviation, IC, before the registration number signifies that registration was performed
based on a declaration of conformity indicating that Industry Canada technical specifications were met. It does not imply
that Industry Canada approved the equipment.
FCC Digital Device Warnings
This equipment complies with Part 68 of the FCC rules and the requirements adopted by ACTA. On the interface card
module of this equipment is a label that contains a product identifier in the format US: AC1ISNANIPM260UNI. If
requested this number must be provided to the telephone company.
The Telephone Company may make changes in the facilities, equipment, operations or procedures that could affect the
operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make
necessary modifications to maintain uninterrupted service. Should you experience trouble with this telephone
equipment, contact: AudioCodes Inc, San Jose, CA USA. Tel: [phone]. Do not attempt to repair this
equipment!
Facility Interface Code: 04DU9.BN, 04DU9.DN, 04DU9.1KN, 4DU9.ISN
Service Order Code: 6.0F
USOC Jack Type: RJ48C
It this gateway causes harm to the telephone network, the telephone company will notify you in advance that temporary
discontinuance of service may be required. But if advance notice isn’t practical, the telephone company will notify the
customer as soon as possible. Also you will be advised of your right to file complaint with the FCC if you believe it is
necessary.
Network Information and Intent of Use
The products are for access to ISDN at 2048 kb/s and for access to G.703 Leased lines at 2048 kb/s.
Network Compatibility
The products support the Telecom networks in EU that comply with TBR4 and TBR13.
Telecommunication Safety
The safety status of each port is declared and detailed in the table below:
Ports Safety Status
E1 or T1 TNV-1
Ethernet (100 Base-TX) SELV
TNV-1: Telecommunication network voltage circuits whose normal operating voltages do not exceed the limits for SELV
SELV: Safety extra low voltage circuit.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.