User`s manual

Mediant 2000 & TP-1610 & TP-260
SIP User's Manual 398 Document #: LTRT-68805
Safety Notices
1. Installation and service of this gateway must only be performed by authorized, qualified service personnel.
2. The protective earth terminal on the device must be permanently connected to protective earth.
3. The equipment must be connected by service personnel to a socket-outlet with a protective earthing connection.
4. This equipment should be installed in restricted access locations with maximum allowed temperature 40°C (104°F).
Industry Canada Notice
This equipment meets the applicable Industry Canada Terminal Equipment technical specifications. This is confirmed
by the registration numbers. The abbreviation, IC, before the registration number signifies that registration was
performed based on a declaration of conformity indicating that Industry Canada technical specifications were met. It
does not imply that Industry Canada approved the equipment.
Digital Device Warnings
This equipment complies with Part 68 of the FCC rules and the requirements adopted by ACTA. On the bottom of this
equipment is a label that contains a product identifier in the format US: AC1ISNANTP1610. If requested this number
must be provided to the telephone company.
The Telephone company may make changes in the facilities, equipment, operations or procedures that could affect the
operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make
necessary modifications to maintain uninterrupted service. Should you experience trouble with this telephone
equipment, contact: AudioCodes Inc, San Jose, CA USA. Tel: [phone]. Do not attempt to repair this
equipment!
Facility Interface Code: 04DU9.BN, 04DU9.DN, 04DU9.1KN, 4DU9.ISN
Service Order Code: 6.0F
USOC Jack Type: RJ21X or RJ48C
It this gateway causes harm to the telephone network, the telephone company will notify you in advance that temporary
discontinuance of service may be required. But if advance notice isn’t practical, the telephone company will notify the
customer as soon as possible. Also you will be advised of your right to file complaint with the FCC if you believe it is
necessary.
Network Information and Intent of Use
The products are for access to ISDN at 2048 kb/s and for access to G.703 Leased lines at 2048 kb/s.
Network Compatibility
The products support the Telecom networks in EU that comply with TBR4 and TBR13.
Telecommunication Safety
The safety status of each port is declared and detailed in the table below:
Ports Safety Status
E1 or T1 TNV-1
Ethernet (100 Base-TX) SELV
DC input port
(applicable only when DC powered)
SELV
TNV-1: Telecommunication network voltage circuits whose normal operating voltages do not exceed the limits for SELV
under normal operating conditions and on which over voltages from telecommunication networks are possible.
SELV: Safety extra low voltage circuit.