User`s manual

Mediant 2000 & TP-1610 & TP-260
SIP User's Manual 386 Document #: LTRT-68805
Table I-8: acBoardOverloadAlarm Alarm Trap
Alarm:
acBoardOverloadAlarm
OID:
1.3.6.1.4.1.5003.9.10.1.21.2.0.11
Default Severity
Major
Event Type:
processingErrorAlarm
Probable Cause:
softwareError (46)
Alarm Text:
Board overload alarm
Status Changes:
Condition:
An overload condition exists in one or more of the system components.
Alarm Status: Major
Condition:
The overload condition passed
Alarm Status: Cleared
I.1.2 Component: AlarmManager#0
The source varbind text for all the alarms under this component is
Board#<n>/AlarmManager#0 where n is the slot number.
Table I-9: acActiveAlarmTableOverflow Alarm Trap
Alarm:
acActiveAlarmTableOverflow
OID:
1.3.6.1.4.15003.9.10.1.21.2.0.12
Default Severity
Major
Event Type:
processingErrorAlarm
Probable Cause:
resourceAtOrNearingCapacity (43)
Alarm Text:
Active alarm table overflow
Status Changes:
Condition:
Too many alarms to fit in the active alarm table
Alarm status: major
Condition:
After raise
Alarm status: Status stays major until reboot. A clear trap is not sent.
Note: The status stays major until reboot as it denotes a possible loss of information
until the next reboot. If an alarm is raised when the table is full, it is possible that
the alarm is active, but does not appear in the active alarm table.
Corrective Action:
Some alarm information may have been lost, but the ability of the device to
perform its basic operations has not been impacted. A reboot is the only way to
completely clear a problem with the active alarm table. Contact your first-level
group.