User`s manual
Table Of Contents
- Mediant 2000 & TP-1610 & TP-260/UNI SIP User’s Manual Version 5.0
- Table of Contents
- List of Figures
- List of Tables
- Notices
- 1. Overview
- 2. Physical Description
- 3. Installation
- 4. Getting Started
- 5. Web Management
- Computer Requirements
- Protection and Security Mechanisms
- Accessing the Embedded Web Server
- Getting Acquainted with the Web Interface
- Protocol Management
- Advanced Configuration
- Status & Diagnostic
- Software Update Menu
- Maintenance
- Logging Off the Embedded Web Server
- 6. Gateway's ini File Configuration
- Secured ini File
- Modifying an ini File
- The ini File Content
- The ini File Structure
- The ini File Example
- Networking Parameters
- System Parameters
- Web and Telnet Parameters
- Security Parameters
- RADIUS Parameters
- SNMP Parameters
- SIP Configuration Parameters
- Voice Mail Parameters
- ISDN and CAS Interworking-Related Parameters
- Number Manipulation and Routing Parameters
- E1/T1 Configuration Parameters
- Channel Parameters
- Configuration Files Parameters
- 7. Using BootP / DHCP
- 8. Telephony Capabilities
- Working with Supplementary Services
- Configuring the DTMF Transport Types
- Fax & Modem Transport Modes
- Event Notification using X-Detect Header
- ThroughPacket™
- Dynamic Jitter Buffer Operation
- Configuring the Gateway’s Alternative Routing (based on Conn
- Call Detail Report
- Supported RADIUS Attributes
- Trunk to Trunk Routing Example
- Proxy or Registrar Registration Example
- SIP Call Flow Example
- SIP Authentication Example
- 9. Networking Capabilities
- 10. Advanced PSTN Configuration
- 11. Advanced System Capabilities
- 12. Special Applications
- 13. Security
- 14. Diagnostics
- 15. SNMP-Based Management
- SNMP Standards and Objects
- Carrier Grade Alarm System
- Cold Start Trap
- Third-Party Performance Monitoring Measurements
- TrunkPack-VoP Series Supported MIBs
- Traps
- SNMP Interface Details
- SNMP Manager Backward Compatibility
- Dual Module Interface
- SNMP NAT Traversal
- SNMP Administrative State Control
- AudioCodes’ Element Management System
- 16. Configuration Files
- Appendix A. Selected Technical Specifications
- Appendix B. Supplied SIP Software Kit
- Appendix C. SIP Compliance Tables
- Appendix D. The BootP/TFTP Configuration Utility
- Appendix E. RTP/RTCP Payload Types and Port Allocation
- Appendix F. RTP Control Protocol Extended Reports (RTCP-XR)
- Appendix G. Accessory Programs and Tools
- Appendix H. Release Reason Mapping
- Appendix I. SNMP Traps
- Appendix J. Installation and Configuration of Apache HTTP Server
- Appendix K. Regulatory Information
SIP User's Manual I. SNMP Traps
Version 5.0 385 October 2006
Table I-5: acFeatureKeyError Alarm Trap
Alarm:
acFeatureKeyError
OID:
1.3.6.1.4.1.5003.9.10.1.21.2.0.6
Default Severity
Critical
Event Type:
processingErrorAlarm
Probable Cause:
configurationOrCustomizationError (7)
Alarm Text:
Feature key error
Status Changes:
Note:
Support of this alarm is pending
Table I-6: acBoardCallResourcesAlarm Alarm Trap
Alarm:
acBoardCallResourcesAlarm
OID:
1.3.6.1.4.1.5003.9.10.1.21.2.0.8
Default Severity
Major
Event Type:
processingErrorAlarm
Probable Cause:
softwareError (46)
Alarm Text:
Call resources alarm
Status Changes:
Condition:
Number of free channels exceeds the predefined RAI high threshold.
Alarm Status: Major
Note: To enable this alarm the RAI mechanism must be activated (EnableRAI = 1).
Condition:
Number of free channels falls below the predefined RAI low threshold.
Alarm Status: Cleared
Table I-7: acBoardControllerFailureAlarm Alarm Trap
Alarm:
acBoardControllerFailureAlarm
OID:
1.3.6.1.4.1.5003.9.10.1.21.2.0.9
Default Severity
Minor
Event Type:
processingErrorAlarm
Probable Cause:
softwareError (46)
Alarm Text:
Controller failure alarm
Status Changes:
Condition:
Proxy has not been found
Alarm Status: Major
Additional
Info:
Proxy not found. Use internal routing
or
Proxy lost. looking for another Proxy
Condition:
Proxy is found.
The clear message includes the IP address of this Proxy.
Alarm Status: Cleared