User`s manual

Mediant 2000 & TP-1610 & TP-260
SIP User's Manual 38 Document #: LTRT-68805
¾ To place the device on a 19-inch rack’s shelf, take these 2 steps:
1. Place the device on the preinstalled shelf.
2. You’re now recommended to take the optional steps of fastening the device to the
frame of the rack (as described above) while it is placed on the shelf, so preventing it
from sliding when inserting cables into connectors on the rear panel.
3.1.4 Cabling the Mediant 2000
Refer to Chapter 2 on page 27 for detailed information on the Mediant 2000 rear panel
connectors and LEDs. Note that the Mediant 2000 is available in many configurations, i.e.,
AC or DC, in the 16-trunk, 8-trunk, 4-trunk, 2-trunk or 1-trunk device. The 16-trunk dual AC
(Figure
3-3) and the 8-trunk DC (Figure 3-4) configurations are illustrated here as
representative products.
Figure 3-3: Mediant 2000 Rear Panel Cabling (16 Trunks, Dual AC Power)
Table 3-1: Mediant 2000 Rear Panel Cabling (16 Trunks, Dual AC Power) Component
Descriptions
Item # Label Component Description
1
RTM locking screws.
2
ETHERNET
Two Category 5 network cables, connected to the 2 Ethernet RJ-45 ports.
3
TRUNKS Two 50-pin Telco connector cables (at least 26 AWG UTP), each
supporting 8 trunks.
4
Protective earthing screw.
5
100-240~1.5A
Dual AC power cables.