User`s manual

SIP User's Manual D. The BootP/TFTP Configuration Utility
Version 5.0 363 October 2006
Table D-1: Command Line Switch Descriptions
Switch Description
-fb Burn ram.cmp in flash (only for cmp files)
-em # Use this switch to set Ethernet mode.
0 = 10 Base-T half-duplex
1 = 10 Base-T full-duplex
2 = 100 Base-TX half-duplex
3 = 100 Base-TX full-duplex
4 = auto-negotiate (default)
For detailed information on Ethernet interface configuration, refer to Section
9.1 on page 229.
This parameter is used to:
Note: This switch takes effect only from the next gateway reset.
-br
Set the number of BootP requests the gateway
sends during start-up. The gateway stops
sending BootP requests when either BootP reply
is received or number of retries is reached.
1 = 1 BootP retry, 1 second
2 = 2 BootP retries, 3 seconds
3 = 3 BootP retries, 6 seconds
4 = 10 BootP retries, 30 seconds
5 = 20 BootP retries, 60 seconds
6 = 40 BootP retries, 120 seconds
7 = 100 BootP retries, 300 seconds
15 = BootP retries indefinitely
Set the number of DHCP packets the gateway
sends.
After all packets were sent, if there's still no reply,
the gateway loads from flash.
1 = 4 DHCP packets
2 = 5 DHCP packets
3 = 6 DHCP packets (default)
4 = 7 DHCP packets
5 = 8 DHCP packets
6 = 9 DHCP packets
7 = 10 DHCP packets
15 = 18 DHCP packets
-bd BootP delays. Sets the interval between the device’s start-up and the first BootP/DHCP request that
is issued by the device. The switch only takes effect from the next reset of the device.
1 = 1 second delay (default).
2 = 10 second delay.
3 = 30 second delay.
4 = 60 second delay.
5 = 120 second delay.
-bs Use –bs 1 to enable the Selective BootP mechanism.
Use –bs 0 to disable the Selective BootP mechanism.
The Selective BootP mechanism (available from Boot version 1.92) enables the gateway’s integral
BootP client to filter unsolicited BootP/DHCP replies (accepts only BootP replies that contain the
text ‘AUDC’ in the vendor specific information field). This option is useful in environments where
enterprise BootP/DHCP servers provide undesired responses to the gateway’s BootP requests.
-be Use -be 1 for the device to send device-related initial startup information (such as board type,
current IP address, software version) in the vendor specific information field (in the BootP request).
This information can be viewed in the main screen of the BootP/TFTP, under column 'Client Info‘
(refer to Figure
D-1 showing BootP/TFTP main screen with the column 'Client Info' on the extreme
right). For a full list of the vendor specific Information fields, refer to Section
7.3 on page 205.
Note: This option is not available on DHCP servers.